Hyundai Venue (QX): Rear View Monitor (RVM) / Description and operation

Hyundai Venue (QX) (2020-2026) Service Manual / Advanced Driver Assistance System (ADAS) / Rear View Monitor (RVM) / Description and operation

Description
Rear view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position.
This system is a supplemental system that shows behind the vehicle through the AV monitor or the ECM (Reverse Display Room Mirror) mirror while backing-up.
Hyundai Venue. Description and operation   
This system is a supplementary function only. It is the responsibility of the driver or always check the inside/ outside rear view mirror and the area behind the vehicle before and while backing up because there is a dead zone that can't see through the camera.

    Component Location 1. Rear view camera 2. AVN monitor

    Removal 1. Remove the rear bumper cover. (Refer to Body - "Rear Bumper Cover") 2. Loosen the mounting screws and remove the rear view camera.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Start/Stop Button. Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crashpad lower panel. (Refer to BODY - "Crashpad Lower Panel") 3. Disconnect the SSB connector (A).

    Hyundai Venue (QX) (2020-2026) Service Manual: Description and operation

    Description Rear Corner Radar is a system that measures the relative speed and distance from the following vehicles by using two electromagnetic wave radar sensors attached to the rear bumper, and detects any vehicle within the blind spot zone and gives off alarm.

    Categories

     
    Copyright В© 2026 www.hvenueqx.com - 0.0105