Hyundai Venue (QX): Crankshaft Position Sensor (CKPS) / Description and operation
Hyundai Venue (QX) (2020-2026) Service Manual / Engine Control / Fuel System / Engine Control System / Crankshaft Position Sensor (CKPS) / Description and operation
| Description |
Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one
of the most important sensors of the engine control system. If there is no CKPS
signal input, fuel is not supplied.That is, vehicle can't run without CKPS signal.
This sensor is installed on the cylinder block or the transaxle housing and
generates alternating current by magnetic flux field which is made by the sensor
and the target wheel when engine runs.
The target wheel consists of 58 slots and 2 missing slots on 360 degrees CA
(Crank Angle).
Specification Item Specification Coil Resistance (Ω) 774 - 946 [20°C (68°F)] pin 2
Other information:
Hyundai Venue (QX) (2020-2026) Service Manual: Heater Unit. Components and components location
Component Location 1. Heater unit assembly Compoents 1. Mode control actuator 2. Heater core case 3. Center duct seal 4. PTC heater 5. Heater core assembly 6. Heater case [LH] 7.
Hyundai Venue (QX) (2020-2026) Service Manual: Description and operation
Description and Operation Blcok Diagram • This system monitors the driving situations through the radar and the camera. Thus, for a situation out of the sensing range, the system may not normally operate.
Categories
- Manuals Home
- Hyundai Venue Owners Manual
- Hyundai Venue Service Manual
- Normal Maintenance Schedule
- Tire Pressure Monitoring System (TPMS) (Type A)
- Maintenance
- New on site
- Most important about car
Copyright © 2026 www.hvenueqx.com - 0.016