Hyundai Venue (QX): Interior Trim / Door Scuff Trim. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Interior Trim / Door Scuff Trim. Repair procedures

Replacement
[Front]
Hyundai Venue. Door Scuff Trim. Repair procedures   
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Using a flat-tip screwdriver or remover, remove the front door scuff trim (A).

Hyundai Venue. Door Scuff Trim. Repair procedures
2.
To install, reverse removal procedure.
Hyundai Venue. Door Scuff Trim. Repair procedures   
•
Replace any damaged clips (or pin-type retainers).
[Rear]
Hyundai Venue. Door Scuff Trim. Repair procedures   
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the rear seat cushion cover
(Refer to Rear Seat - "Rear Seat Cushion Cover")
2.
Loosen the mounting screws and remove the rear door scuff trim (A).

Hyundai Venue. Door Scuff Trim. Repair procedures
3.
To install, reverse removal procedure.
Hyundai Venue. Door Scuff Trim. Repair procedures   
•
Replace any damaged clips (or pin-type retainers).

    Component Location 1. Front door scuff trim 2. Rear door scuff trim

    Component Location 1. Cowl side trim

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Blower Motor. Repair procedures

    Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor does not operate well, substitute with a known-good blower motor and check for proper operation.

    Hyundai Venue (QX) (2020-2026) Service Manual: Special service tools

    Special Service Tools Tool Name / Number Illustration Description LKA Compensator (09890-3V100) Used for compensating front view camera unit BCW Sensor Correction Tool Set (09958-3T500) Used to correct the blin

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0129