Hyundai Venue (QX): Airbag Module / Driver Airbag (DAB) Module and Clock Spring. Description and operation

Hyundai Venue (QX) (2020-2026) Service Manual / Restraint / Airbag Module / Driver Airbag (DAB) Module and Clock Spring. Description and operation

Description
•
Driver Air Bag (DAB)
DAB is installed in the steering wheel, and electrically connected to the SRSCM via clock spring. It is deployed during frontal impact to protect the driver.
•
Clock Spring
Clock spring delivers actuation signal, generated by the sensors installed in the front and right/left sides of a vehicle, to the inflator (gas generator) of the driver air bag module via internal cable.
It also delivers actuation signal of the steering wheel remote control switch and horn to relevant systems via internal cable.
Hyundai Venue. Driver Airbag (DAB) Module and Clock Spring. Description and operation   
•
Never attempt to measure the circuit resistance of the airbag module (squib) even if you are using the specified tester. If the circuit resistance is measured with a tester, accidental airbag deployment will result in serious personal injury.

    Components 1. Driver Air Bag (DAB) 2. Steering Wheel 3. Clock Spring

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Receiver-Drier. Repair procedures

    Replacement 1. Remove the condenser. 2. Remove the cap (A) on the bottom of the condenser with a L wrench. Tightening torque : 9.81 - 14.71 N.m (1.

    Hyundai Venue (QX) (2020-2026) Service Manual: Blower Resistor (Manual). Repair procedures

    Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0109