| Removal and Installation |
| 1. |
Remove the Roll rod mounting (A).
|
| 2. |
Remove the roll rod mounting suppot bracket (A).
|
| 3. |
Installation is reverse order of removal.
|
| 1. |
Install the jack to the edge of upper oil pan to support the engine.
|
| 2. |
Remove the engine mounting support bracket (A).
|
| 3. |
Removal the engine mounting bracket (A).
|
| 4. |
Installation is reverse order of removal.
|
| 1. |
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
|
| 2. |
Install the jack to the edge of transaxle.
|
| 3. |
Remove the cover (A).
|
| 4. |
Remove the transaxle support bracket mounting bolt (A).
|
| 5. |
Remove the transaxle mounting bracket (A).
|
| 6. |
Installation is reverse order of removal.
|
Components 1. Engine mounting bracket 2. Engine mounting support bracket 3. Roll road bracket 4. Transaxle mounting bracket
Removal • Use fender covers to avoid damaging painted surfaces.
Inspection 1. Disconnect the ignition switch connector (B) and key warning switch connector (A) from under the steering column. 2. Check for continuity between the terminals. 3.
Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low pressure and low temperature refrigerant gas into high pressure and high temperature refrigerant gas.