Hyundai Venue (QX): Body Side Molding / Fender Garnish. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Body Side Molding / Fender Garnish. Repair procedures

Replacement
Hyundai Venue. Fender Garnish. Repair procedures   
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Take care not to scratch the body surface.
1.
Using a remover, remove the fender garnish (A).

Hyundai Venue. Fender Garnish. Repair procedures
2.
To install, reverse removal procedure.
Hyundai Venue. Fender Garnish. Repair procedures   
•
Replace any damaged clips (or pin-type retainers).

    Replacement    • Put on gloves to prevent hand injuries.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Components and components location

    Component Location [Engine Room] 1. Condenser 2. Discharge hose 3. Suction & Liquid tube assembly 4. Compressor 5. Service port (High pressure) 6. A/C Pressure transducer (APT) 7. Service port (Low pressure) 8.

    Hyundai Venue (QX) (2020-2026) Service Manual: Blower Motor. Repair procedures

    Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor does not operate well, substitute with a known-good blower motor and check for proper operation.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0125