Hyundai Venue (QX): Heating, Ventilation and Air Conditioning / Specifications

Hyundai Venue (QX) (2020-2026) Service Manual / Heating, Ventilation and Air Conditioning / Specifications

Specification
Air Conditioner
item
Specification
Compressor
 Type
 DVE12N
Oil type & Capacity
 PAG 30 120 ± 10cc (4.23 ± 0.34oz.)
Displacement
 122 cc / rev
Expansion valve
 Type
 Block type
Refrigerant
 Type
 R - 134a
Capacity
 470 ± 25g (16.6 ± 0.88oz)

Blower Unit
Item
Specification
Fresh and recirculation
 Operating method
 Actuator
Blower
 Type
 Sirocco pan
Speed step
 Auto + 8 speed (Automatic), 1 - 4 speed (Manual)
Speed control
 Power mosfet (Automatic), Resistor (Manual)
Air filter
 Type
 Particle filter

Heater and Evaporator Unit
Item
Specification
Heater
 Type
 Fin & Tube type
Type
 Tube - Fin 1Way
Mode operating method
 Actuator
Temperature operating method
 Actuator
Evaporator
 Temperature control type
 Evaporator temperature sensor
Blower singular
 A/C Output OFF Temperature
 A/C Output ON Temperature
Manual control
0.5 °C (32.9 °F)
 1.5 °C (34.7 °F)
Dual control
0.5 °C (32.9 °F)
 1.5 °C (34.7 °F)
Manufacturer
 DOOWON

Tightening Torques
Items
N.m
kgf.m
lb-ft
Compressor
 20.0 - 32.95
 2.04 - 3.36
 14.75 - 24.30
Condenser - Discharge hose
 8.8 - 13.7
 0.9 - 1.4
 6.5 - 10.1
Condenser - Liquid tube
Compressor - Discharge hose
 21.6 - 32.4
 2.2 - 3.3
 15.9 - 23.9
Compressor - Suction hose
Expansion valve - Evaporator
 8.8 - 13.7
 0.9 - 1.4
 6.5 - 10.1

    Troubleshooting Problem Symptoms Table Before replacing or repairing air conditioning components, first determine if the malfunction is due to the refrigerant charge, air flow or compressor.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Ambient Temperature Sensor. Repair procedures

    Inspection 1. Check the resistance of the ambient temperature sensor between terminals 1 and 2 whether it changes by changing the ambient temperature. 1. Ambient Sensor (+) 2.

    Hyundai Venue (QX) (2020-2026) Service Manual: Warning Indicator. Components and components location

    Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim. (Refer to Body - "Front door trim") 3. Disconnect the power door mirror connector from the harness 4.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0146