Hyundai Venue (QX): Floor Console / Floor Console Assembly. Repair procedures

Replacement
Hyundai Venue. Floor Console Assembly. Repair procedures   
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the gear knob & gear boots (A) pull both of it up.

Hyundai Venue. Floor Console Assembly. Repair procedures

Hyundai Venue. Floor Console Assembly. Repair procedures

2.
Using a remover and remove the console upper cover (A).

Hyundai Venue. Floor Console Assembly. Repair procedures

3.
Press the lock pin and separate the various connectors (A).

Hyundai Venue. Floor Console Assembly. Repair procedures

4.
Remove the storage box pad (A).

Hyundai Venue. Floor Console Assembly. Repair procedures

5.
Remove the parking brake cover (A).

Hyundai Venue. Floor Console Assembly. Repair procedures

6.
Loosen the mounting bolts and remove the rear console assembly (A).

Hyundai Venue. Floor Console Assembly. Repair procedures

7.
Loosen the mounting screws, clips and remove the front console assembly (A).

Hyundai Venue. Floor Console Assembly. Repair procedures

8.
To install, reverse removal procedure.
Hyundai Venue. Floor Console Assembly. Repair procedures   
•
Make sure the connector is connected properly.
•
Replace any damaged clips (or pin-type retainers).

    Component Location 1. Front console assembly 2. Rear console assembly

    Replacement    • Put on gloves to prevent hand injuries.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Compressor oil. Repair procedures

    Oil Specification 1. The HFC-134a system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed. 2. Compressor (PAG) oil varies according to compressor model.

    Hyundai Venue (QX) (2020-2026) Service Manual: Intake Actuator. Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the intake actuator connector. 3. Verify that the intake actuator operates to the fresh position when connecting 12V to terminal 3 and grounding terminal 4.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0122