Hyundai Venue (QX): Floor Console / Rear Console Cover. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Floor Console / Rear Console Cover. Repair procedures

Replacement
Hyundai Venue. Rear Console Cover. Repair procedures   
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the floor console assembly.
(Refer to Floor Console - "Floor Console Assembly")
2.
Using a remover and remove the rear console cover (A).

Hyundai Venue. Rear Console Cover. Repair procedures
3.
To install, reverse removal procedure.

    Replacement    • Put on gloves to prevent hand injuries.

    Replacement    • Put on gloves to prevent hand injuries.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Description and operation

    Description Rear Corner Radar is a system that measures the relative speed and distance from the following vehicles by using two electromagnetic wave radar sensors attached to the rear bumper, and detects any vehicle within the blind spot zone and gives off alarm.

    Hyundai Venue (QX) (2020-2026) Service Manual: Parking Distance Warning (PDW) Sensor. Repair procedures

    Removal 1. Remove the bumper cover. (Refer to Body - "Front Bumper Cover") 2. Disconnect the connector (A) from the PDW sensor. [L - Type] Installation 1.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0153