| Replacement |
|
| 1. |
Remove the front seat assembly.
(Refer to Front Seat - "Front Seat Assembly")
|
| 2. |
Remove the front seat shield outer cover.
(Refer to Front Seat - "Front Seat Shield Outer Cover")
|
| 3. |
Remove the front seat shield inner cover.
(Refer to Front Seat - "Front Seat Shield Inner Cover")
|
| 4. |
Push the lock pin and remove the front seat headrest (A).
|
| 5. |
Remove the front seat lower protector (A).
|
| 6. |
Remove the front seat back board (A).
|
| 7. |
Pull out the headrest guides (A) while pinching both side of the lower
part of the guides, and remove them.
|
| 8. |
Separate the side airbag connector (A).
|
| 9. |
Remove the front seat back protector (A).
|
| 10. |
Remove the front seat back lower protector (A) and front seat back cover.
|
| 11. |
After removing the hog-ring clips (A) inside the front seat back cover,
remove the seat back cover (B).
|
| 12. |
To install, reverse removal procedure.
|
Component Location 1. Front seat back cover
Component Location 1. Front seat cushion cover
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the evaporator temperature sensor connector. 3. Measure the resistance between terminal "+" and "-" of the evaporator temperature sensor.
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater unit assembly. (Refer to Heater - "Heater Unit") 3. Separate the evaporator temperature sensor connector (A), loosen the mounting screws and remove the eva