Hyundai Venue (QX): Front Seat / Front Seat Cushion Cover. Repair procedures

Replacement
Hyundai Venue. Front Seat Cushion Cover. Repair procedures   
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
1.
Remove the front seat assembly.
(Refer to Front Seat - "Front Seat Assembly")
2.
Remove the front seat shield outer cover.
(Refer to Front Seat - "Front Seat Shield Outer Cover")
3.
Remove the front seat shield inner cover.
(Refer to Front Seat - "Front Seat Shield Inner Cover")
4.
Remove the front seat lower protector (A).

Hyundai Venue. Front Seat Cushion Cover. Repair procedures

5.
Remove the front seat cushion protector (A) from front seat cushion frame.
[Lower]

Hyundai Venue. Front Seat Cushion Cover. Repair procedures

[Upper]

Hyundai Venue. Front Seat Cushion Cover. Repair procedures

[RH]

Hyundai Venue. Front Seat Cushion Cover. Repair procedures

[LH]

Hyundai Venue. Front Seat Cushion Cover. Repair procedures

6.
Separate the seat inner type (A).

Hyundai Venue. Front Seat Cushion Cover. Repair procedures

7.
After removing the hog-ring clips (A) inside the front seat back cover, remove the seat back cover (B).
Hyundai Venue. Front Seat Cushion Cover. Repair procedures   
•
Be careful not to break the sponge insert wire.

Hyundai Venue. Front Seat Cushion Cover. Repair procedures

8.
To install, reverse removal procedure.
Hyundai Venue. Front Seat Cushion Cover. Repair procedures   
•
Make sure that the connectors are connected completely.
•
Replace any damaged clips (or pin-type retainers).
•
To prevent wrinkles, make sure that the cover (B) is stretched evenly before connecting the hog-ring clips (A).
•
Replace the hog-ring clips with new ones using special tool (C) (09880-4F000).

Hyundai Venue. Front Seat Cushion Cover. Repair procedures

    Component Location 1. Front seat cushion cover

    Component Location 1. Front seat back frame assembly 2. Front seat cushion frame assembly

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Special service tools

    Special Service Tools Tool Name / Number Illustration Description LKA Compensator (09890-3V100) Used for compensating front view camera unit BCW Sensor Correction Tool Set (09958-3T500) Used to correct the blin

    Hyundai Venue (QX) (2020-2026) Service Manual: Description and operation

    Description Rear view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position. This system is a supplemental system that shows behind the vehicle through the AV monitor or the ECM (Reverse Display Room Mirror) mirror while backing-up.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0101