Hyundai Venue (QX): Front Seat / Front Seat Shield Outer Cover. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Front Seat / Front Seat Shield Outer Cover. Repair procedures

Replacement
Hyundai Venue. Front Seat Shield Outer Cover. Repair procedures   
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the front seat assembly.
(Refer to Front Seat - "Front Seat Assembly")
2.
Using a remover and remove the front seat height nob cap (A).

Hyundai Venue. Front Seat Shield Outer Cover. Repair procedures
3.
Loosen the mounting screws and remove the front seat height nob (A).

Hyundai Venue. Front Seat Shield Outer Cover. Repair procedures
4.
Loosen the mounting screw and remove the front seat recliner lever (A).

Hyundai Venue. Front Seat Shield Outer Cover. Repair procedures
5.
Remove the front seat outer shield cover (A) by pulling forward in the direction of the arrow using screw driver or remover.

Hyundai Venue. Front Seat Shield Outer Cover. Repair procedures
6.
To install, reverse removal procedure.
Hyundai Venue. Front Seat Shield Outer Cover. Repair procedures   
•
Replace any damaged clips (or pin-type retainers).

    Component Location 1. Front seat shield outer cover

    Component Location 1. Front seat shield inner cover

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: In-car Sensor. Repair procedures

    Diagnosis With GDS 1. The heating, ventilation and air conditioning can be quickly diagnosed failed parts with vehicle diagnostic system (GDS). ※ The diagnostic system (GDS) provides the following information.

    Hyundai Venue (QX) (2020-2026) Service Manual: Ambient Temperature Sensor. Description and operation

    Description The ambient temperature sensor is located at the front of the condenser and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower temperature, and decrease with higher temperature.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0192