Hyundai Venue (QX): Body Side Molding / Front Wheel Guard. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Body Side Molding / Front Wheel Guard. Repair procedures

Replacement
Hyundai Venue. Front Wheel Guard. Repair procedures   
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Take care not to scratch the body surface.
1.
Remove the front tire.
2.
Loosen the mounting clip, nuts and screws and remove the front wheel guard (A).

Hyundai Venue. Front Wheel Guard. Repair procedures
3.
To install, reverse removal procedure.
Hyundai Venue. Front Wheel Guard. Repair procedures   
•
Replace any damaged clips (or pin-type retainers).

    Replacement    • Put on gloves to prevent hand injuries.

    Replacement    • Put on gloves to prevent hand injuries.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Temperature Control Actuator. Description and operation

    Description The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch.

    Hyundai Venue (QX) (2020-2026) Service Manual: Components and components location

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0143