Hyundai Venue (QX): Body Side Molding / Rear Wheel Guard. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Body Side Molding / Rear Wheel Guard. Repair procedures

Replacement
Hyundai Venue. Rear Wheel Guard. Repair procedures   
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Take care not to scratch the body surface.
1.
Remove the rear tire.
2.
Loosen the mounting clip and remove the rear wheel guard (A).

Hyundai Venue. Rear Wheel Guard. Repair procedures
3.
To install, reverse removal procedure.
Hyundai Venue. Rear Wheel Guard. Repair procedures   
•
Replace any damaged clips (or pin-type retainers).

    Replacement    • Put on gloves to prevent hand injuries.

    Replacement    • Put on gloves to prevent hand injuries.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Compressor. Description and operation

    Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low pressure and low temperature refrigerant gas into high pressure and high temperature refrigerant gas.

    Hyundai Venue (QX) (2020-2026) Service Manual: Blower Unit. Components and components location

    Component Location 1. Blower unit assembly Component Location 1. Intake seal 2. Intake upper case 3. Intake actuator 4. Intake door 5. Intake lower case 6. Blower pad 7.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0165