| Replacement |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the console upper front garnish.
(Refer to Floor Console - "Floor Console Assembly")
|
| 3. |
Remove the center fascia panel.
(Refer to Body (Interior and Exterior) - "Center Fascia Panel")
|
| 4. |
Remove the audio and AVN head unit.
(Refer to Body Electrical System - "Audio Unit")
|
| 5. |
Loosen the mounting screws and remove the A/C & heater controller unit
(A).
|
| 6. |
Separate the manual controller cable (A)
|
| 7. |
Separate the A/C & heater controller unit connector (A).
|
| 8. |
To install, reverse the removal procedure.
|
Components Connector [A] Pin NO Function Pin NO Function 1 Low 4 Middle Low 2 COMMON 5 Middle High 3 Ground 6 High Connector [B] Pin NO Function Pin NO Function 1 Battery Power 17 IGN2 2 ISG B+ 18 IGN1 3 ILL+ (TAIL) 19 - 4 Sensor REF (+5) 20 - 5 - 21 PTC Relay 1 6 Intake actuator (F/B) 22 - 7 EVAP Sensor (+) 23 MAX Blower ON Signal 8 AMB Sensor (+) 24 - 9 - 25 - 10 - 26 C_CAN High 11 Intake actuator (Fresh Air) 27 C_CAN Low 12 Intake actuator (Recirculated Air) 28 - 13 HTD (Rear defog indicator) 29 ECV+ 14 Rear defog switch 30 ECV(-) 15 Blower ON signal to common 31 Sensor ground 16 ILL- (RHEO) 32 Ground
Components Connector [A] Pin NO Function Pin NO Function 1 Battery (+) 21 IGN2 2 ISG B+ 22 IGN1 3 ILL+ (TAIL) 23 Blower motor (+) 4 Sensor REF (+5V) 24 Photo sensor (-) 5 Mode actuator feedback 25 - 6 Temperature actuator feedback 26 - 7 Intake actuator feedback 27 - 8 EVAP Sensor (+) 28 - 9 AMB Sensor (+) 29 - 10 Mode actuator (Vent) 30 PTC Relay 1 11 Mode actuator (Defrost) 31 - 12 Temperature actuator (Cool) 32 - 13 Temperature actuator (Warm) 33 C_CAN High 14 Intake actuator (Fresh Air) 34 C_CAN Low 15 Intake actuator (Recirculated Air) 35 Power mosfet (Drain feed back) 16 HTD (Rear defog indicator) 36 Power mosfet (Gate) 17 Rear defog switch 37 ECV (+) 18 - 38 ECV (-) 19 - 39 Sensor ground 20 ILL- (RHEO) 40 Ground
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel (A). (Refer to Body - "Crash Pad Lower Panel") 3. Remove the crash pad lower switch (A).
Replacement 1. Open the glove box. 2. Press both sides of the glove box (A) and take it out. 3. Remove the filter cover (A) by pressing the knob. 4.