Hyundai Venue (QX): Heating, Ventilation and Air Conditioning / Controller
- Heater & A/C Control Unit (Manual). Components and components location
- Heater & A/C Control Unit (Manual). Repair procedures
- Heater & A/C Control Unit (DATC). Components and components location
- Heater & A/C Control Unit (DATC). Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the intake actuator connector. 3.
Components Connector [A] Pin NO Function Pin NO Function 1 Low 4 Middle Low 2 COMMON 5 Middle High 3 Ground 6 High Connector [B] Pin NO Function Pin NO Function 1 Battery Power 17 IGN2 2 ISG B+ 18 IGN1 3 ILL+ (TAIL) 19 - 4 Sensor REF (+5) 20 - 5 - 21 PTC Relay 1 6 Intake actuator (F/B) 22 - 7 EVAP Sensor (+) 23 MAX Blower ON Signal 8 AMB Sensor (+) 24 - 9 - 25 - 10 - 26 C_CAN High 11 Intake actuator (Fresh Air) 27 C_CAN Low 12 Intake actuator (Recirculated Air) 28 - 13 HTD (Rear defog indicator) 29 ECV+ 14 Rear defog switch 30 ECV(-) 15 Blower ON signal to common 31 Sensor ground 16 ILL- (RHEO) 32 Ground
Other information:
Hyundai Venue (QX) (2020-2026) Service Manual: Repair procedures
Inspection The following section describes how to diagnose faults using a diagnostic instrument. 1. Connect the cable of GDS to the data link connector in driver side crash pad lower panel, and turn on the GDS.
Hyundai Venue (QX) (2020-2026) Service Manual: Blower Unit. Components and components location
Component Location 1. Blower unit assembly Component Location 1. Intake seal 2. Intake upper case 3. Intake actuator 4. Intake door 5. Intake lower case 6. Blower pad 7.
Categories
- Manuals Home
- Hyundai Venue Owners Manual
- Hyundai Venue Service Manual
- Specifications
- Warning and Indicator Lights
- Remote Key
- New on site
- Most important about car
