Hyundai Venue (QX): Engine Control System / Injector. Schematic diagrams
| Circuit Diagram |
Specification Item Specification Coil Resistance (Ω) 14.5 [20°C (68°F)] pin 2
Inspection 1. Turn ignition switch OFF. 2. Disconnect injector connector. 3.
Other information:
Hyundai Venue (QX) (2020-2025) Service Manual: Temperature Control Actuator. Description and operation
Description The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch.
Hyundai Venue (QX) (2020-2025) Service Manual: Blower Resistor (Manual). Repair procedures
Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.
Categories
- Manuals Home
- Hyundai Venue Owners Manual
- Hyundai Venue Service Manual
- Restraint
- Repair procedures
- Repair procedures
- New on site
- Most important about car
