Hyundai Venue (QX): Blower / Intake Actuator. Components and components location
| Components Location |
| 1. Intake actuator |
Replacement 1. Open the glove box. 2. Press both sides of the glove box (A) and take it out.
Description The intake actuator is located at the blower unit. It regulates the intake door by a signal from the control unit. Pressing the intake selection switch will shift between recirculation and fresh air modes.
Other information:
Hyundai Venue (QX) (2020-2026) Service Manual: Repair procedures
Inspection The following section describes how to diagnose faults using a diagnostic instrument. 1. Connect the cable of GDS to the data link connector in driver side crash pad lower panel, and turn on the GDS.
Hyundai Venue (QX) (2020-2026) Service Manual: Blower Resistor (Manual). Repair procedures
Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.
Categories
- Manuals Home
- Hyundai Venue Owners Manual
- Hyundai Venue Service Manual
- Tire Pressure Monitoring System (TPMS) (Type A)
- Engine Coolant
- Child-Protector Rear Door Locks
- New on site
- Most important about car
