| Components |

| 1. Gasket 2. Oil screen 3. Oil pan |
4. Drain plug gasket 5. Drain plug |
Removal and Installation 1. Disconnect the battery negative terminal. 2. Remove the engine room under cover.
Removal 1. Disconnect the battery negative terminal. 2. Remove the engine room under cover.
Inspection The following section describes how to diagnose faults using a diagnostic instrument. 1. Connect the cable of GDS to the data link connector in driver side crash pad lower panel, and turn on the GDS.
Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.