Hyundai Venue (QX): Rear Bumper / Rear Bumper beam Assembly. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Rear Bumper / Rear Bumper beam Assembly. Repair procedures

Replacement
Hyundai Venue. Rear Bumper beam Assembly. Repair procedures   
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the rear bumper cover.
(Refer to Rear Bumper - "Rear Bumper Cover")
2.
Disconnect the rear bumper beam mounting wiring harness (A).

Hyundai Venue. Rear Bumper beam Assembly. Repair procedures
3.
Loosen the mounting clips, remove the rear bumper beam assembly (A).

Hyundai Venue. Rear Bumper beam Assembly. Repair procedures
4.
To install, reverse removal procedure.
Hyundai Venue. Rear Bumper beam Assembly. Repair procedures   
•
Make sure the connector is plugged in properly.
•
Replace any damaged clips (or pin-type retainers).

    Component Location 1. Rear bumper beam assembly

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Intake Actuator. Components and components location

    Hyundai Venue (QX) (2020-2026) Service Manual: Troubleshooting

    Trouble Symptom Charts Trouble Symptom 1 Trouble Symptom 2 Trouble symptom Probable cause Remedy The set vehicle speed varies greatly upward or downward "Surging" (repeated alternating acceleration and deceleration) occurs after setti

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0182