| Replacement |
|
| 1. |
Loosen the mounting screws and remove the rear combination lamp (A).
|
| 2. |
Press the lock pin and separate the rear combination lamp connector
(A).
|
| 3. |
Loosen the mounting clip and screw.
|
| 4. |
Loosen the mounting clips and screws on the side of rear bumper (A),
detach the side part of rear bumper.
|
| 5. |
Loosen the mounting clips, nuts and remove the rear side under cover
(A).
|
| 6. |
Press the lock pin and separate the rear bumper main connector (B).
|
| 7. |
Loosen the mounting bolts and remove the rear bumper cover (A).
|
| 8. |
To install, reverse removal procedure.
|
Component Location 1. Rear bumper cover
Component Location 1. Rear bumper beam assembly
Replacement 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative (-) battery terminal.
Replacement 1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery / recycling / charging station. 3. When the engine is cool, drain the engine coolant from the radiator.