| Replacement |
| [Rear door side weatherstrip] |
| 1. |
Loosen the rear door checker (B) mounting bolt.
|
| 2. |
Detach the clips, then remove the rear door side weatherstrip (A).
|
| 3. |
To install, reverse removal procedure.
|
| [Rear door body side weatherstrip] |
| 4. |
Remove the rear door body side weatherstrip (A).
|
| 5. |
To install, reverse the removal procedure.
|
Replacement 1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2.
Component Location 1. Rear door latch
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the evaporator temperature sensor connector. 3. Measure the resistance between terminal "+" and "-" of the evaporator temperature sensor.
Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.