Hyundai Venue (QX): Rear Door / Rear Door Trim. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Trim. Repair procedures

Replacement
Hyundai Venue. Rear Door Trim. Repair procedures   
•
When removing with a flat-tip screwdriver or remover,wrap protective tape around the tools to preventdamage to components.
•
Take care not to scratch the body surface.
1.
Loosen the mounting screw and remove the rear door trim (A).

Hyundai Venue. Rear Door Trim. Repair procedures
2.
Press the lock pin and separate the rear door inside handle case (A) and power window connector (B).

Hyundai Venue. Rear Door Trim. Repair procedures
3.
To install, reverse removal procedure.
Hyundai Venue. Rear Door Trim. Repair procedures   
•
Make sure the connector is connected properly.
•
Make sure the door locks / unlocks and opens / closes properly.
•
Replace any damaged clips (or pin-type retainers).
•
Make sure the glass is operated properly.

    Component Location 1. Rear door trim

    Component Location 1. Rear door window glass

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Heater & A/C Control Unit (Manual). Repair procedures

    Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the console upper front garnish. (Refer to Floor Console - "Floor Console Assembly") 3.

    Hyundai Venue (QX) (2020-2026) Service Manual: Heater & A/C Control Unit (DATC). Repair procedures

    Self Diagnosis 1. Self-diagnosis process.    • When operating the self-diagnostics, the below fault(self-diagnostics code) will blink at 0.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0128