| Component Location |

| 1. Rear door window glass |
Replacement • When removing with a flat-tip screwdriver or remover,wrap protective tape around the tools to preventdamage to components.
Replacement • When removing with a flat-tip screwdriver or remover,wrap protective tape around the tools to preventdamage to components.
Replacement 1. Remove the condenser. 2. Remove the cap (A) on the bottom of the condenser with a L wrench. Tightening torque : 9.81 - 14.71 N.m (1.
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4.