Hyundai Venue (QX): General Information / Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Engine Mechanical System / General Information / Repair procedures

Compession Pressure Inspection
Hyundai Venue. Repair procedures   
•
If the there is lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure.
1.
Make sure the oil in the crankcase is of the correct viscosity and at the correct level and that the battery is correctly charged. Operate the vehicle until the engine is at normal operating temperature. Turn the ignition switch to the OFF position.
2.
Remove the engine center cover.
3.
Remove the ignition coil (A).

Hyundai Venue. Repair procedures
4.
Remove the spark plugs.
Using a 16mm plug wrench, remove the 4 spark plugs.
5.
Check the cylinder compression pressure.
(1)
Insert a compression gauge into the spark plug hole.

Hyundai Venue. Repair procedures
(2)
Set the throttle plate in the wide-open position.
(3)
While cranking the engine, measure the compression pressure.
Hyundai Venue. Repair procedures   
•
Always use a fully charged battery to obtain engine speed of 250rpm or more.
(4)
Repeat step 1) through 3) for each cylinder.
Hyundai Venue. Repair procedures   
•
This measurement must be done in as short time as possible.
Compression pressure
Standard : 1225.83kPa (12.5kg/cm², 177.79psi) (200-250 rpm)
Minimum : 1078.73kPa (11.0kg/cm², 156.46psi)
Difference between each cylinder :
98kPa (1.0kg/cm², 14psi) or less
(5)
If the cylinder compression in one or more cylinders is low, pour a small amount of engine oil into the cylinder through the spark plug hole and repeat step 1) through 3) for cylinders with low compression.
•
If adding oil helps the compression, it is likely that the piston rings and/or cylinder bore are worn or damaged.
•
If pressure stays low, a valve may be sticking or seating is improper, or there may be leakage past the gasket.
6.
Install the spark plugs.
7.
Install the ignition coil (A).

Hyundai Venue. Repair procedures
8.
Install the engine center cover.
Tightening torque :
7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)

    Specifications Description Specifications Limit General Type In-line, DOHC 　 Number of cylinders 4 　 Bore 77 mm (3.

    Troubleshooting Symptom Suspect area Remedy Engine misfire with abnormal internal lower engine noises.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Head Lamp Leveling Switch. Repair procedures

    Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel (A). (Refer to Body - "Crash Pad Lower Panel") 3. Remove the crash pad lower switch (A).

    Hyundai Venue (QX) (2020-2026) Service Manual: Evaporator Core. Repair procedures

    Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater unit assembly. (Refer to Heater - "Heater Unit") 3. Separate the evaporator temperature sensor connector (A), loosen the mounting screws and remove the eva

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0136