Hyundai Venue (QX): Crankshaft Position Sensor (CKPS) / Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Engine Control / Fuel System / Engine Control System / Crankshaft Position Sensor (CKPS) / Repair procedures

Inspection
Wave Form
1.
Check signal waveform of CKPS and CMPS using a diagnostic tool.
Specification : Refer to "DTC Guide"
Coil Resistance
1.
Turn the ignition switch OFF.
2.
Disconnect the knock sensor connector.
3.
Measure resistance between the CKPS terminals 1 and 2.
4.
Check that the resistance is within the specification.
Specification : 774 - 946Ω [20°C (68°F)]
Removal
1.
Turn ignition switch OFF and disconnect the battery negative (-) terminal.
2.
Lift the vehicle.
3.
Disconnect the crankshaft position sensor connector (A).
4.
Remove the CKP sensor after removing the installation bolt (B).
Crankshaft position sensor installation bolt :
7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)

Hyundai Venue. Repair procedures
Installation
Hyundai Venue. Repair procedures   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Hyundai Venue. Repair procedures   
•
Apply the engine oil to the O-ring.
•
Insert the sensor in the installation hole and be careful not to damage when installation.
Hyundai Venue. Repair procedures   
•
Be careful not to damage the sensor housing and the connector.
•
Be careful not to damage the O-ring.
1.
Install in the reverse order of removal.

    Circuit Diagram [M/T] [A/T] Harness Connector

    Description Camshaft Position Sensor (CMPS) is a hall sensor and detects the camshaft position by using a hall element. It is related with Crankshaft Position Sensor (CKPS) and detects the piston position of each cylinder which the CKPS can't detect.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Repair procedures

    Inspection 1. Disconnect the ignition switch connector (B) and key warning switch connector (A) from under the steering column. 2. Check for continuity between the terminals. 3.

    Hyundai Venue (QX) (2020-2026) Service Manual: Immobilizer Control Unit. Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the glove box. (Refer to Body - "Glove Box Housing") 3. Remove the smart key unit (A) after loosening the nuts.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0152