Hyundai Venue (QX): Brake Pedal / Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Brake System / Brake Pedal / Repair procedures

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3.
Disconnect the brake switch connector (A).

Hyundai Venue. Repair procedures
4.
Disconnect the snap pin (A) and clevis pin (B).

Hyundai Venue. Repair procedures
5.
Remove the brake pedal assembly after loosening the mounting and nuts (A).
Tightening torque :
16.7 - 25.5 N.m (1.7 - 2.6 kgf.m, 12.3 - 18.8 lb-ft)

Hyundai Venue. Repair procedures

Hyundai Venue. Repair procedures
Inspection
1.
Check the bushing for wear.
2.
Check the brake pedal for bending or twisting.
3.
Check the brake pedal return spring for damage.
Installation
1.
Install in the reverse order of removal.

    Components 1. Brake member assembly 2. Stop lamp switch 3. Brake pedal arm assembly 4. Brake pedal pad

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Blower Unit. Repair procedures

    Replacement 1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery / recycling / charging station. 3. When the engine is cool, drain the engine coolant from the radiator.

    Hyundai Venue (QX) (2020-2026) Service Manual: Description and operation

    Description and Operation Blcok Diagram    • This system monitors the driving situations through the radar and the camera. Thus, for a situation out of the sensing range, the system may not normally operate.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.016