| Components |

| 1. Brake member assembly 2. Stop lamp switch |
3. Brake pedal arm assembly 4. Brake pedal pad |
Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the crash pad lower panel.
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the glove box. (Refer to Body - "Glove Box Housing") 3. Remove the smart key unit (A) after loosening the nuts.
Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.