Hyundai Venue (QX): Floor Carpet / Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Floor Carpet / Repair procedures

Replacement
Hyundai Venue. Repair procedures   
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the floor console assembly.
(Refer to Floor Console - "Floor Console Assembly")
2.
Remove the front seat assembly.
(Refer to Front Seat - "Front Seat Assembly")
3.
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
4.
Remove the cowl side trim.
(Refer to Interior Trim - "Cowl Side Trim")
5.
Remove the center pillar lower trim.
(Refer to Interior Trim - "Center Pillar Trim")
6.
Remove the floor carpet assembly (A).
7.
To install, reverse removal procedure.
Hyundai Venue. Repair procedures   
•
Replace any damaged clips (or pin-type retainers).

Hyundai Venue. Repair procedures

1. Floor floor carpet assembly

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: A/C Pressure Transducer. Repair procedures

    Inspection    • Before measuring the pressure of the refriferant line, check whether the refrigerant amount is charged in accordance with the specified charging amount.

    Hyundai Venue (QX) (2020-2026) Service Manual: PTC Heater. Repair procedures

    Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0183