Hyundai Venue (QX): Body (Interior and Exterior) / Special service tools

Special Service Tools
Tool (Number and name)
Illustration
Use
09880-4F000
Hog ring clip installer

Hyundai Venue. Special service tools

Hog ring clip installation

    Specifications Items Specification Hood Type Rear hinged, stay rod type Front Door Construction Front hinged, frame door construction Regulator system Wire drum type Locking system Pin-fork system Rear Door Construction Front hinged, frame door construction Regulator system Wire drum type Locking system Pin-fork system Tail Gate Type Front hinged, gas lifter type Seat Belts Front 3 point type with Emergency Locking Retractor (E.

    Troubleshooting Symptom Passible Cause Remedy (Refer to page) Water leaks from sunroof Deteriorated roof lid weatherstrip Replace Excessive roof lid-to-body clearance and improperly fitted weatherstrip Adjust Wind noise around sunroof Loose or deformed deflector, gaps in body work Retighten adjust or replace Noise created by moving sunroof lid Foreign particles lodged in guide rail Check drive cable and guide rails for foreign particles Loose guide rails and lid Retighten Motor runs but sunroof does not move or moves only partially Foreign particles lodged in guide rail Adjust or replace Incorrect engagement of motor pinion with drive cable Decrease in motor's clutch slipping force Increased sunroof sliding resistance or interference of sunroof with drive cables, weatherstrip, etc.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Photo Sensor. Description and operation

    Description The photo sensor is located at the center of the defrost nozzles. The photo sensor contains a photovoltaic (sensitive to sunlight) diode. The solar radiation received by its light receiving portion, generates an electromotive force in proportion to the amount of radiation received which is transferred to th

    Hyundai Venue (QX) (2020-2026) Service Manual: Repair procedures

    Removal 1. Remove the rear bumper cover. (Refer to Body - "Rear Bumper Cover") 2. Loosen the mounting screws and remove the rear view camera. Installation 1.

    Categories

     
    Copyright В© 2026 www.hvenueqx.com - 0.014