Hyundai Venue (QX): Sunroof / Sunroof Assembly. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Sunroof / Sunroof Assembly. Repair procedures

Replacement
Hyundai Venue. Sunroof Assembly. Repair procedures   
•
When removing with a flat - tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Put on glove to protect your hands.
1.
Remove the roof trim.
(Refer to Roof Trim - "Roof Trim Assembly")
2.
Press the lock pin and separate the roof wiring connector (A).

Hyundai Venue. Sunroof Assembly. Repair procedures
3.
After loosening the mounting bolts, then remove the assist handle bracket (A).

Hyundai Venue. Sunroof Assembly. Repair procedures
4.
Disconnect the drain tubes (B).
5.
After loosening the mounding nuts and bolts, remove the sunroof assembly (A).
Tightening torque :
Bolt : 7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)
Nut : 3.9 - 5.9 N.m (0.4 - 0.6 kgf.m, 2.9 - 4.3 lb-ft)

Hyundai Venue. Sunroof Assembly. Repair procedures
6.
To install, reverse the removal procedure.
Hyundai Venue. Sunroof Assembly. Repair procedures   
•
Make sure to initialize the motor.

    Components Location 1. Sunroof assembly

    Replacement 1. Remove the sunroof assembly. (Refer to Sunroof - "Sunroof Assembly") 2.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Description and operation

    Description Rear Corner Radar is a system that measures the relative speed and distance from the following vehicles by using two electromagnetic wave radar sensors attached to the rear bumper, and detects any vehicle within the blind spot zone and gives off alarm.

    Hyundai Venue (QX) (2020-2026) Service Manual: Specifications

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0135