Hyundai Venue (QX): Roof Trim / Sunvisor. Repair procedures

Replacement
Hyundai Venue. Sunvisor. Repair procedures   
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Loosen the mounting screw and seperate the sunvisor (A).

Hyundai Venue. Sunvisor. Repair procedures

2.
Loosen the mounting screws and remove the retainer (A).

Hyundai Venue. Sunvisor. Repair procedures

3.
To install, reverse removal procedure.
Hyundai Venue. Sunvisor. Repair procedures   
•
Replace any damaged clips (or pin-type retainers).

    Component Location 1. Sunvisor 2. Retainer

    Component Location 1. Assist handle

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Temperature Control Actuator. Description and operation

    Description The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch.

    Hyundai Venue (QX) (2020-2026) Service Manual: Blower Unit. Components and components location

    Component Location 1. Blower unit assembly Component Location 1. Intake seal 2. Intake upper case 3. Intake actuator 4. Intake door 5. Intake lower case 6. Blower pad 7.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0139