Hyundai Venue (QX): Driveshaft Assembly / TJ Joint. Components and components location
| Components |
| [RH] |
| 1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot |
5. Dynamic damper 6. Shaft 7. TJ boot band 8. TJ boot |
9. Spider assembly 10. Snap ring 11. TJ housing 12. Clip |
| [LH] |
| 1. BJ assembly 2. Circlip 3. BJ boot band 4. BJ boot |
5. Shaft 6. TJ boot band 7. TJ boot 8. Spider assembly |
9. Snap ring 10. TJ Case 11. Clip |
Removal 1. Remove the front driveshaft. (Refer to Driveshaft Assembly - "Front Driveshaft") 2.
Disassembly • Special grease must be applied to the driveshaft joint.
Other information:
Hyundai Venue (QX) (2020-2026) Service Manual: Repair procedures
Inspection 1. Disconnect the ignition switch connector (B) and key warning switch connector (A) from under the steering column. 2. Check for continuity between the terminals. 3.
Hyundai Venue (QX) (2020-2026) Service Manual: Repair procedures
Removal 1. Remove the rear bumper cover. (Refer to Body - "Rear Bumper Cover") 2. Loosen the mounting screws and remove the rear view camera. Installation 1.
Categories
- Manuals Home
- Hyundai Venue Owners Manual
- Hyundai Venue Service Manual
- Remote Key
- Front Suspension System
- Child-Protector Rear Door Locks
- New on site
- Most important about car
