Hyundai Venue (QX): Tire Pressure Monitoring System / TPMS Receiver. Repair procedures

Replacement
[TPMS Receiver (Integrated Body Control Unit (IBU))]
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the glove box.
(Refer to Body - "Glove Box Housing")
3.
Remove the IBU (A) after loosening the bolt and nut.

Hyundai Venue. TPMS Receiver. Repair procedures

4.
Disconnect the IBU connector (A).

Hyundai Venue. TPMS Receiver. Repair procedures

Diagnosis procedure by using diagnostic device
The main contents of diagnostic method using diagnostic device are as follows:
1.
Connect self-diagnosis connector (16 pins) located in the lower driver side crash pad to self-diagnosis device, and then turn on the self-diagnosis device after key is ON.
2.
Select the "vehicle model" and "TPMS" on GDS vehicle selection screen, then select OK.
[Vehicle Name Writing Method]

Hyundai Venue. TPMS Receiver. Repair procedures

Hyundai Venue. TPMS Receiver. Repair procedures

Hyundai Venue. TPMS Receiver. Repair procedures

Hyundai Venue. TPMS Receiver. Repair procedures

Hyundai Venue. TPMS Receiver. Repair procedures

[Wheel Sensor ID Writing Method]

Hyundai Venue. TPMS Receiver. Repair procedures

Hyundai Venue. TPMS Receiver. Repair procedures

Hyundai Venue. TPMS Receiver. Repair procedures

Hyundai Venue. TPMS Receiver. Repair procedures

Hyundai Venue. TPMS Receiver. Repair procedures

    Description TPMS Receiver : Integrated Body Control Unit (IBU) integrated management 1. Mode (1) Virgin State • The receiver as a sole part is shipped in this state.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Troubleshooting

    Troubleshooting Problem Symptoms Table Before replacing or repairing air conditioning components, first determine if the malfunction is due to the refrigerant charge, air flow or compressor. Use the table below to help you find the cause of the problem.

    Hyundai Venue (QX) (2020-2026) Service Manual: Description and operation

    Description Rear view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position. This system is a supplemental system that shows behind the vehicle through the AV monitor or the ECM (Reverse Display Room Mirror) mirror while backing-up.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0174