Hyundai Venue (QX): Driveshaft and axle / Troubleshooting

Hyundai Venue (QX) (2020-2026) Service Manual / Driveshaft and axle / Troubleshooting

Troubleshooting
Trouble Symptom
Probable cause
Remedy
Vehicle pulls to one side
 Scoring of driveshaft ball joint
 Replace
Wear, rattle or scoring of wheel bearing
 Replace
Defective front suspension and steering
 Adjustment or Replace
Vibartion
 Wear, damage or bending of driveshaft
 Replace
Driveshaft rattle and hub serration
 Replace
Wear, rattle or scratching of wheel bearing
 Replace
Shimmy
 Defective wheel balance
 Adjustment or Replace
Defective front suspension and steering
 Adjustment or Replace
Excessive noise
 Wear, damage or bending of driveshaft
 Replace
Rattle of driveshaft and worn hub splines
 Replace
Wear, rattle or scoring of wheel bearing
 Replace
Loose hub nut
 Adjustment or Replace
Defective front suspension and steering
 Adjustment or Replace

    Special Service Tools Tool(Number and Name) Illustration Use 09495-39100 Band installer Installation of hook type boot band 09495-3K000 Band installer Installation of ear type boot band 09495-33000 Puller Remove the spider assembly from the drive shaft 09568-1S100 Ball joint puller Remove the ball joint front axle

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Immobilizer Control Unit. Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the glove box. (Refer to Body - "Glove Box Housing") 3. Remove the smart key unit (A) after loosening the nuts.

    Hyundai Venue (QX) (2020-2026) Service Manual: PTC Heater. Description and operation

    Description The PTC (Positive Temperature Coefficient) heater is installed at the exit or the backside of heater core. The PTC heater is an electric heater using a PTC element as an auxiliary heating device that supplements deficiency of interior heat source in highly effective diesel engine.

    Categories

     
    Copyright В© 2026 www.hvenueqx.com - 0.016