Hyundai Venue (QX): Rear Corner Radar System / Warning Indicator. Components and components location
| Inspection |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front door trim.
(Refer to Body - "Front door trim")
|
| 3. |
Disconnect the power door mirror connector from the harness
|
| 4. |
Check that the mirror operates properly as shown in the below table.
|
| Removal |
| 1. |
Disconnect (-) battery terminal.
|
| 2. |
Using a fastener remover (C), remove the mirror (A) as illustration
below.
|
| 3. |
Disconnect heat wire connectors (A) and then remove the mirror.
|
| Installation |
| 1. |
Connect mirror heat wire connector and then install the mirror.
|
| 2. |
Connect (-) battery terminal then check if mirror works normally.
|
Removal lf replacement of the rear corner radar unit bracket or extension wire is required, replace the defective part only with a new one.
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim.
Other information:
Hyundai Venue (QX) (2020-2026) Service Manual: Condenser. Repair procedures
Inspection 1. Check the condenser fins for clogging and damage. If clogged, clean them with water, and blow them with compressed air. If bent, gently bend them using a screwdriver or pliers. 2.
Hyundai Venue (QX) (2020-2026) Service Manual: A/C Pressure Transducer. Description and operation
Description The A/C Pressure Transducer (APT) converts the pressure value of high pressure line into voltage value after measuring it. By converted voltage value, engine ECU controls the cooling fan by operating it high speed or low speed.
Categories
- Manuals Home
- Hyundai Venue Owners Manual
- Hyundai Venue Service Manual
- Liftgate
- Front Suspension System
- Instrument Cluster
- New on site
- Most important about car
