Hyundai Venue (QX): Rear Corner Radar System / Warning Indicator. Repair procedures

Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door trim.
(Refer to Body - "Front door trim")
3.
Disconnect the power door mirror connector from the harness

Hyundai Venue. Warning Indicator. Repair procedures

4.
Check that the mirror operates properly as shown in the below table.

Hyundai Venue. Warning Indicator. Repair procedures

Removal
1.
Disconnect (-) battery terminal.
2.
Using a fastener remover (C), remove the mirror (A) as illustration below.

Hyundai Venue. Warning Indicator. Repair procedures

Hyundai Venue. Warning Indicator. Repair procedures

Hyundai Venue. Warning Indicator. Repair procedures   
•
Protect mirror from removing tool with cloth (B) wrapped.
•
Be careful not to damage mirror and mirror housing during removing process.
•
Apply force around the center of mirror because to apply force the end of mirror will break it.
3.
Disconnect heat wire connectors (A) and then remove the mirror.

Hyundai Venue. Warning Indicator. Repair procedures

Installation
1.
Connect mirror heat wire connector and then install the mirror.
2.
Connect (-) battery terminal then check if mirror works normally.

    Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Components and components location

    Hyundai Venue (QX) (2020-2026) Service Manual: In-car Sensor. Description and operation

    Description The In-car air temperature sensor is built in the heater & A/C control unit. The sensor contains a thermistor which measures the temperature of the inside. The signal decided by the resistance value which changes in accordance with perceived inside temperature, is delivered to heater control unit and accord

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.015