Hyundai Venue (QX): Cooling System / Water Temperature Control Assembly. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Engine Mechanical System / Cooling System / Water Temperature Control Assembly. Repair procedures

Removal and Installation
1.
Disconnect the battery negative terminal.
2.
Loosen the drain plug, and drain the engine coolant. Remove the radiator cap to drain with speed.
3.
Remove the air cleaner assembly.
(Refer to Intake and exhaust system - "Air Cleaner")
4.
Disconnect the water temperature sensor connector.
(Refer to Engine Control / Fuel System - "Engine Control System")
5.
Disconnect the radiator upper hose (A).

Hyundai Venue. Water Temperature Control Assembly. Repair procedures
6.
Remove the heater hose(A).

Hyundai Venue. Water Temperature Control Assembly. Repair procedures
7.
Disconnect the coolant hose(A).

Hyundai Venue. Water Temperature Control Assembly. Repair procedures
8.
Remove the water temperature control assembly (A).
Tightening torque :
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 10.1 lb-ft)

Hyundai Venue. Water Temperature Control Assembly. Repair procedures
9.
Remove the intake manifold.
(Refer to Intake and Exhaust System - "Intake Manifold")
10.
Remove the water pipe (A).
Tightening torque :
M6 bolt:
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)
M8 bolt:
18.6 - 23.5 N.m (1.9 - 2.4 kgf.m, 13.7 - 17.4 lb-ft)

Hyundai Venue. Water Temperature Control Assembly. Repair procedures
11.
Install in the reverse order of removal.

    Removal and Installation    • Never remove the radiator cap when the engine is hot.

    Components 1. Gasket 2. Water pump 3. Water pump pulley

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Compressor. Repair procedures

    Removal    Precautions for using the plastic pulley • Be careful not to place the pulley to downwards of the floor or table.

    Hyundai Venue (QX) (2020-2026) Service Manual: Heater Unit. Components and components location

    Component Location 1. Heater unit assembly Compoents 1. Mode control actuator 2. Heater core case 3. Center duct seal 4. PTC heater 5. Heater core assembly 6. Heater case [LH] 7.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0157