Hyundai Venue: Cruise Control / To temporarily accelerate with the Cruise Control ON, Cruise Control will be
canceled when
To temporarily accelerate with the Cruise Control ON
Depress the accelerator pedal. When you take your foot off the accelerator, the
vehicle will return to the previously set speed.
If you push the toggle switch down (SET-) at the increased speed, the Cruise
Control will maintain the increased speed.
Cruise Control will be canceled when:

- Depressing the brake pedal.
- Pressing the CANCEL button located on the steering wheel.
- Pressing the CRUISE button. Both the cruise indicator and the "SET" indicator
will turn OFF.
- Moving the shift lever into N (Neutral). (for automatic transmission/dual
clutch transmission vehicle)
- Decreasing the vehicle speed to less than approximately 20 MPH (30 km/h).
- The ESC (Electronic Stability Control) is operating.
- Downshifting to the 2nd gear in manual shift mode. (for intelligent variable
transmission vehicle)
Information
Each of the above actions will cancel Cruise Control operation (the "SET"
indicator in the instrument cluster will go off), but only pressing the CRUISE button
will turn the system off. If you wish to resume Cruise Control operation, push the
toggle switch up (RES+) located on your steering wheel. You will return to your
previously preset speed, unless the system was turned off using the CRUISE button.
To increase Cruise Control speed
Push the toggle switch up (RES+) and hold it, while monitoring the SET speed
on the instrument cluster. The set speed will increase by 5 MPH (8 km/h) increments...
To resume preset Cruising speed
Push the toggle switch up (RES+). If the vehicle speed is over 20 MPH (30 km/h),
the vehicle will resume the preset speed...
Other information:
Description
Exhaust emissions (CO, HC, NOx) are controlled by a combination of engine modifications
and the addition of special control components.
Modifications to the combustion chamber, intake manifold, camshaft and ignition
system form the basic control system...
Removal
1.
Separate the push rod (A) from the clutch pedal.
2.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
3.
Remove the air cleaner and air duct...
Categories

1. Instrument cluster
2. Horn
3. Key ignition switch/ Engine Start/Stop button
4. Infotainment system
5. Hazard warning flasher switch
read more