| Singal Waveform |

Specification Temperature [°C (°F)] Resistance (kΩ) -40 (-40) 40.93 - 48.35 -30 (-22) 23.
Circuit Diagram [M/T] [A/T] Harness Connector
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel (A). (Refer to Body - "Crash Pad Lower Panel") 3. Remove the crash pad lower switch (A).
Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.