Hyundai Venue: Intake Air Temperature Sensor (IATS) / Schematic diagrams
[M/T]

[A/T]

Harness Connector

Inspection
1.
Turn ignition switch OFF.
2.
Disconnect IATS connector.
3.
Measure resistance between IATS terminals 3 and 4...
Other information:
The rear corner radars are located inside the rear bumper for detecting the side
and rear areas. Always keep the rear bumper clean for proper operation of the system.
NOTICE
The system may not work properly when the bumper has been damaged, or
if the rear bumper has been replaced or repaired...
The following items must be serviced more frequently on cars normally used under
severe driving conditions. Refer to the chart below for the appropriate maintenance
intervals.
I: Inspect and if necessary, adjust, correct, clean or replace.
R : Replace or change...
Categories
Seat belt warning light (for driver’s seat)

As a reminder to the driver, the seat belt warning light will illuminate for
approximately 6 seconds each time you place the ignition switch to the ON position
regardless of belt fastening. However, if the seat belt is unfasted, a warning chime
will sound for approximately 6 seconds.
read more