Hyundai Venue: Exterior Lights / Turn signals and lane change signals

To signal a turn, push down on the lever for a left turn or up for a right turn
in position (A).
If an indicator stays on and does not flash or if it flashes abnormally, one
of the turn signal bulbs may be burned out and will require replacement.
Onetouch turn signal function
To activate the One Touch Turn Signal function, push the turn signal lever up
or down to position (B) and then release it.
The lane change signals will blink 3, 5 or 7 times.
You can activate or deactivate the One Touch Turn Signal function or choose the
number of blinks (3, 5, or 7) from the User Settings mode in the LCD display.
High Beam Assist (HBA) is a system that automatically adjusts the headlamp range
(switches between high beam and low beam) according to the brightness of other vehicles
and road conditions...
Battery saver function
The purpose of this feature is to prevent the battery from being discharged.
The system automatically turns off the parking lamp when the driver turns the vehicle
off and opens the driver-side door...
Other information:
Description
Rear view camera will activate when the backup light is ON with the ignition
switch ON and the shift lever in the R position.
This system is a supplemental system that shows behind the vehicle through the
AV monitor or the ECM (Reverse Display Room Mirror) mirror while backing-up...
You can check the tire pressure in the Assist mode on the cluster. Refer
to the “LCD Display Mode” section in chapter 4.
A “Drive to display” message will appear for the first few minutes of driving
after initial engine start up. If the tire pressure is not displayed after a
few minutes of driving, check the tire pressures...
Categories

1. Door lock/unlock button
2. Outside rearview mirror control switch
3. Central door lock switch
4. Power window switches
5. Power window lock switch
read more