| Inspection |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front door trim.
(Refer to Body - "Front door trim")
|
| 3. |
Disconnect the power door mirror connector from the harness
|
| 4. |
Check that the mirror operates properly as shown in the below table.
|
| Removal |
| 1. |
Disconnect (-) battery terminal.
|
| 2. |
Using a fastener remover (C), remove the mirror (A) as illustration
below.
|
| 3. |
Disconnect heat wire connectors (A) and then remove the mirror.
|
| Installation |
| 1. |
Connect mirror heat wire connector and then install the mirror.
|
| 2. |
Connect (-) battery terminal then check if mirror works normally.
|
Rear Corner Radar Unit. Repair procedures
Warning Indicator. Repair proceduresSeat belt warning light (for driver’s seat)

As a reminder to the driver, the seat belt warning light will illuminate for approximately 6 seconds each time you place the ignition switch to the ON position regardless of belt fastening. However, if the seat belt is unfasted, a warning chime will sound for approximately 6 seconds.