Hyundai Venue: Cylinder Head Assembly / Cylinder Head. Components and components location

Hyundai Venue (QX) (2020-2023) Service Manual / Engine Mechanical System / Cylinder Head Assembly / Cylinder Head. Components and components location

Components

Hyundai Venue. Cylinder Head. Components and components location

1. Cylinder head assembly
2. Mechanical Lash Adjuster (MLA)
3. Retainer lock
4. Retainer
5. Valve stem seal
6. Valve spring
7. Valve spring seat
8. Oil Control Valve (OCV)
9. Exhaust valve
10. Intake valve
11. Cylinder head gasket
12. Camshaaft position sensor

    CVVT & Camshaft. Components and components location

    Components 1. Exhaust camshaft 2. Intake camshaft 3. Exhaust CVVT 4. Intake CVVT 5. Camshaft bearing cap 6...

    Cylinder Head. Repair procedures

    Removal Engine removal is not required for this procedure.    • Use Fender cover to avoid damaging painted surfaces...

    Other information:

    Hyundai Venue (QX) (2020-2023) Service Manual: Repair procedures


    Inspection 1. After disconnecting the vapor hose from the PCV valve, remove the PCV valve. 2. Reconnect the PCV valve to the vapor hose. 3. Run the engine at idle, then put a finger over the open end of the PCV valve and make sure that intake manifold vacuum can be felt...

    Hyundai Venue (QX) (2020-2023) Owners Manual: Securing a child restraint seat with “Tether Anchor” system


    First secure the child restraint with the LATCH lower anchors or the seat belt. If the child restraint manufacturer recommends that the top tether strap be attached, attach and tighten the top tether strap to the top tether strap anchor. Child restraint hook holders are located on the rear of the seatbacks...

    Categories

    Vehicle Identification Number (vin), Vehicle Certification Label

    Vehicle Identification Number (vin)

    Hyundai Venue. Vehicle Identification Number (vin), Vehicle Certification Label

    Frame number

    read more


     
    Copyright © 2023 www.hvenueqx.com