Hyundai Venue: Rear View Monitor (RVM) / Description and operation
Rear view camera will activate when the backup light is ON with the ignition
switch ON and the shift lever in the R position.
This system is a supplemental system that shows behind the vehicle through the
AV monitor or the ECM (Reverse Display Room Mirror) mirror while backing-up.
This system is a supplementary function only. It is the responsibility
of the driver or always check the inside/ outside rear view mirror and
the area behind the vehicle before and while backing up because there
is a dead zone that can't see through the camera.
|
Removal
1.
Remove the rear bumper cover.
(Refer to Body - "Rear Bumper Cover")
2.
Loosen the mounting screws and remove the rear view camera...
Other information:
Use high quality ethylene glycol coolant
Your vehicle is delivered with high quality ethylene glycol coolant in the cooling
system. It is the only type of coolant that should be used because it helps prevent
corrosion in the cooling system, lubricates the water pump and prevents freezing...
Disassembly
•
Use fender covers to avoid damaging painted surfaces.
•
To avoid damaging the cylinder head, wait until the engine coolant
temperature drops below normal temperature (20°C [68°F]) before
removing it...
Categories
Seat belt warning light (for driver’s seat)

As a reminder to the driver, the seat belt warning light will illuminate for
approximately 6 seconds each time you place the ignition switch to the ON position
regardless of belt fastening. However, if the seat belt is unfasted, a warning chime
will sound for approximately 6 seconds.
read more