Hyundai Venue: Driveshaft and axle / Special service tools
Hyundai Venue (QX) (2020-2025) Service Manual / Driveshaft and axle / Special service tools
| Special Service Tools |
|
Tool(Number and Name) |
Illustration |
Use |
|
09495-39100 Band installer |
|
Installation of hook type boot band |
|
09495-3K000 Band installer |
|
Installation of ear type boot band |
|
09495-33000 Puller |
|
Remove the spider assembly from the drive shaft |
|
09568-1S100 Ball joint puller |
|
Remove the ball joint front axle |
Specifications
Specification
Engine
Tramsaxle
Max. permissible angle
Outer
Inner
Gamma 1...
Other information:
Hyundai Venue (QX) (2020-2025) Service Manual: Purge Control Solenoid Valve (PCSV). Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Disconnect PCSV connector. 3. Measure resistance between PCSV terminals 1 and 2. 4. Check that the resistance is within the specification...
Hyundai Venue (QX) (2020-2025) Owners Manual: Warning Light and Message
Check LKA system If there is a problem with the system a message will appear for a few seconds. If the problem continues LKA system failure indicator will illuminate. LKA system failure indicator LKA system failure indicator (yellow) will illuminate if the LKA system is not working properly...
Categories
- Manuals Home
- 1st Generation Venue Owners Manual
- 1st Generation Venue Service Manual
- Remote Key
- Immobilizer System
- Type B, C
- New on site
- Most important about car
Master warning mode
This warning light informs the driver the following situations.
-- Forward Collision-Avoidance Assist system malfunction (if equipped)
-- Forward Collision-Avoidance Assist radar blocked (if equipped)
-- Blind-Spot Collision Warning system malfunction (if equipped)
-- Blind-Spot Collision Warning radar blocked (if equipped)
-- Lamp malfunction (if equipped)
-- High Beam Assist malfunction (if equipped)
-- Tire Pressure Monitoring System (TPMS) malfunction (if equipped)
Copyright © 2025 www.hvenueqx.com