Hyundai Venue: Emission Control System / Description and operation
Hyundai Venue (QX) (2020-2025) Service Manual / Emission Control System / Description and operation
| Description |
Emissions Control System consists of three major systems.
| – |
The Crankcase Emission Control System prevents blow-by gas from releasing
into the atmosphere. This system recycles gas back into the intake manifold
(Closed Crankcase Ventilation Type).
|
| – |
The Evaporative Emission Control System prevents evaporative gas from
releasing into the atmosphere. This system burns gas at appropriate
engine operating condition after gathering it in the canister.
|
| – |
The Exhaust Emission Control System converts the three pollutants [hydrocarbons
(HC), carbon monoxide (CO), and oxides of nitrogen (NOx)] into harmless
substances by using the 3-way catalytic converter.
|
Specifications
Specifications
Purge Control Solenoid Valve (PCSV)
▷ Specification
Item
Specification
Coil Resistance (Ω)
18...
Other information:
Hyundai Venue (QX) (2020-2025) Owners Manual: Special Driving Conditions
Hazardous Driving Conditions When hazardous driving elements are encountered such as water, snow, ice, mud and sand, take the below suggestions: Drive cautiously and keep a longer braking distance. Avoid abrupt braking or steering. When your vehicle is stuck in snow, mud, or sand, use second gear...
Hyundai Venue (QX) (2020-2025) Service Manual: Fuel Filter. Repair procedures
Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - "Fuel Pump") 2. Disconnect the electric pump wiring connector (A) and the fuel sender connector (B)...
Categories
- Manuals Home
- 1st Generation Venue Owners Manual
- 1st Generation Venue Service Manual
- Vehicle Identification Number (vin), Vehicle Certification Label
- To set Cruise Control speed
- Rear Combination Light Bulb Replacement
- New on site
- Most important about car
Air bag collision sensors
WARNING
To reduce the risk of an air bag deploying unexpectedly and causing serious injury or death:
Do not hit or allow any objects to impact the locations where air bags or sensors are installed. Do not perform maintenance on or around the air bag sensors. If the location or angle of the sensors is altered, the air bags may deploy when they should not or may not deploy when they should. Do not install bumper guards or replace the bumper with a nongenuine HYUNDAI parts. This may adversely affect the collision and air bag deployment performance. Place the ignition switch in the LOCK/OFF or ACC position when the vehicle is being towed to prevent inadvertent air bag deployment. Have all air bag repairs conducted by an authorized HYUNDAI dealer.
Copyright © 2025 www.hvenueqx.com