Hyundai Venue: Front Door / Front Door Module. Repair procedures

Hyundai Venue (QX) (2020-2025) Service Manual / Body (Interior and Exterior) / Front Door / Front Door Module. Repair procedures

Replacement
Hyundai Venue. Front Door Module. Repair procedures   
•
When removing with a flat-tip screwdriver or remover,wrap protective tape around the tools to preventdamage to components.
•
Take care not to scratch the body surface.
1.
Remove the front door window glass.
(Refer to Front Door - "Front Door Window Glass")
2.
Remove the front door outside handle.
(Refer to Front Door - "Front Door Outside Handle")
3.
Loosen the front door outside handle screw (A).

Hyundai Venue. Front Door Module. Repair procedures
4.
Loosen the front door latch screws.
Tightening torque :
7.8 - 10.8 N.m (0.7 - 1.1 kgf.m, 5.8 - 8.0 lb-ft)

Hyundai Venue. Front Door Module. Repair procedures
5.
Press the lock pin and separate the front door main connector (A).

Hyundai Venue. Front Door Module. Repair procedures
6.
Loosen the front door moodule bolts and remove the front door module (A).
Tightening torque :
7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)

Hyundai Venue. Front Door Module. Repair procedures
7.
Disconnect the various connector fron the front door module and separate the front door module wiring harness (A).
8.
Remove the front door latch assembly.
(Refer to Front Door - "Front Door Latch Assembly")
9.
Remove the front power window motor.
(Refer to Body Electrical System - "Power Window Motor")
10.
To install, reverse removal procedure.
Hyundai Venue. Front Door Module. Repair procedures   
•
Make sure connectors are connected properly and each rod is connected securely.
•
Make sure the door locks / unlocks and opens / closes properly.

    Front Door Module. Components and components location

    ..

    Front Door Inside Handle. Repair procedures

    Removal 1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2. Cut the heat welds with a knife and remove the front door inside handle (A)...

    Other information:

    Hyundai Venue (QX) (2020-2025) Service Manual: Transaxle Oil Temperature Sensor. Repair procedures


    Removal    • When Diagnostic Trouble Codes (DTC) is on, perform the following procedure to replace it. • Automatic transaxle is composed of delicate components...

    Hyundai Venue (QX) (2020-2025) Service Manual: Front Door Window Glass. Components and components location


    ..

    Categories

    Instrument Panel Overview

    Hyundai Venue. Instrument Panel Overview

    1. Instrument cluster
    2. Horn
    3. Key ignition switch/ Engine Start/Stop button
    4. Infotainment system
    5. Hazard warning flasher switch

    read more


     
    Copyright © 2025 www.hvenueqx.com