Hyundai Venue (QX): Interior Trim / Front Pillar Trim. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Interior Trim / Front Pillar Trim. Repair procedures

Replacement
Hyundai Venue. Front Pillar Trim. Repair procedures   
•
Put on gloves to prevent hand injuries.
Hyundai Venue. Front Pillar Trim. Repair procedures   
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the front pillar trim.
(1)
To remove the front pillar trim, the fastener remover (A) below must be used.

Hyundai Venue. Front Pillar Trim. Repair procedures
(2)
After slightly lifting up the front pillar trim and putting the tool in, remove the mounting clip (A) by pulling it.
Hyundai Venue. Front Pillar Trim. Repair procedures   
•
Once the front pillar trim is removed, be sure to replace the clips with new ones.

Hyundai Venue. Front Pillar Trim. Repair procedures
(3)
Remove the front pillar trim (A).

Hyundai Venue. Front Pillar Trim. Repair procedures
2.
To install, reverse removal procedure.
Hyundai Venue. Front Pillar Trim. Repair procedures   
•
Replace any damaged clips (or pin-type retainers).

    Component Location 1. Front pillar trim

    Component Location 1. Center pillar lower trim 2. Center pillar upper trim

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: ESCL(Electronic Steering Column Lock). Repair procedures

    Removal 1. Disconnect the negative(-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the steering column upper and lower shrouds.

    Hyundai Venue (QX) (2020-2026) Service Manual: Temperature Control Actuator. Description and operation

    Description The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.011