| Component Location |

| 1. Center pillar lower trim |
2. Center pillar upper trim |
Replacement • Put on gloves to prevent hand injuries.
Replacement [Center pillar lower trim] • Put on gloves to prevent hand injuries.
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4.
Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.